How to Build a Patio Mist System Fan
DIY Outdoor Misting Fan
The following directions tell you the way to assemble a low-pressure mist system hoop on a household cooling fan to construct your own portable misting fans. This set up makes it possible for you to make an great misting fan making use of the water pressure out of your yard water spigot. It’s very good for cooling down a couple folks on your deck. It can additionally be put to use to cool off your dog or other pets, or even a small rabbit hutch or chicken coop.
Just what you will need:
- Mist Ring with lo-pressure misting nozzles
- A lo-pressure faucet assembly designed for the mister ring (includes low pressure line, hose bib adapter, zip ties, 1/4-inch push lock fitting for the mist ring).
- Fan - 16 inch or wider
- Power cord extension
- Electrical power Outlet that has a ground fault circuit breaker
- Nearby garden hose bib water faucet.
The faucet adapter should be installed on the tube, but if not, just press the tube directly into the smaller end of the connector. It is a tight fit, hence in the event that you experience difficulty performing this by hand, use a pair of pliers to help force the hose in.
In the event that you purchased a misting fan kit with a misting ring, a push lock fitting will be set up on the ring. If you got the mist fan kit separately, it comes with a push lock connector that you will have to mount onto your misting ring. In case the fitting does not already include plumber’s tape wrapped about it, you are going to need to wrap it 2-3 times, and then install the connector on to the misting ring.
Press the tubing securely into the fitting, then gently pull back to ensure the hose is secure in the connector.
For our demonstration, I’ll be using a relatively inexpensive box fan I purchased at Walmart a few years ago. Lay the fan down, then center the misting ring on the exhaust side of the fan, with the mist nozzles directing away from the fan.
Affix the mist ring to the fan using ties that came with the mister fan adapter kit. Bend over the zip tie first, which will help to make it less difficult to thread in and around the ring and the grill of the fan shroud. Draw the ties snug, then snip off the ends to make it tidy. You can put the fan up-right now, making sure the misting ring is secure.
Plug the fan into a GFCI-protected power outlet. A ground fault protected outlet is the kind with a black “Test” and a red “Reset” button. These electrical outlets cut off the electricity when there is a “ground fault,” which takes place whenever the electric current finds an alternative route to ground. For example, it might try to travel through your body if you happen to be foolish enough to be standing in a puddle of water. Don’t be dumb - always be very careful when using electrical power in the presence of water. In modern-day homes, electrical outlets on the outside of the building are typically on a Gfci circuit or are ground fault outlets. In many homes, the entire GFCI circuit is managed by a ground fault outlet in the garage. You should be sure to check that it is operating properly prior to connecting your misting fan.
Attach the tubing with the faucet adapter to the water spigot.
Immediately after plugging the fan in and flipping it on, you should turn on the water to commence the misting. Now you may cool off with your personal misting fan!
